How to Modify Your Stair Railing by Replacing Balusters?

Stair Railing by Replacing Balusters

Are you looking for a project with little work but great impact? You should take on the project of replacing wooden stairs balusters with metal ones. It’s relatively easy, doesn’t call for many instruments, and has a greater impact than you might think.

It immediately is now a top priority job for when you arrive in your newly bought used home a month later because it may require you to have home improvement

Step 1: Remove any current balusters

Throw your current balusters with a saw. If you have a hand saw, you may quickly see it to the point where the current baluster can be snapped and pulled out. Utilizing pliers that could have come together with the old balusters, remove any nails that may still be there. Check the handrail’s undersides in particular.

STEP 2: Drilling openings for new balusters is step two

The perforations on the bottom of the railings should be large enough for the new balusters; you have to drill a hole in the foundation rails.  After drilling, insert one of the replacement balusters to make sure you made a hole that is big enough. It is okay if the hole is bigger than the new baluster. The hole will be concealed by the metal shoes.

Step 3: Sand

The sand might be found where the base-rail and old balusters met. You can remove any thick paint globs with a little flathead screwdriver before sanding. Sand the transition between painted and unpainted areas until it is seamless.

Step 4: Measure

For the new balusters, take a height measurement. Add the measurement of the distance here between the bottom of the guardrail and the height of the base rail to arrive at this.

Although the size of each baluster must be nearly the same, it doesn’t hurt to verify every few balusters. The balusters on the stairs needed to be somewhat longer with each rise.

Step 5: Paint

You should paint the base rails sanded-down regions. Add more coatings if necessary. Since we would use high-gloss paint, I finished by applying a coat over the complete base rail after you cover up all the sanded areas. This helped to reduce paintbrush strokes. Also know about Paint Kitchen Cabinets tips.

Step 6: Cut the balusters in step six

And using the saw with a metal-cutting blade, size the new balusters toward the proper length (electric or hand). Verify the dimensions again after removing the first baluster to ensure it is accurate.

Continue cutting once you’re sure you have the right size. To avoid unintentional saw blade scratches, mark the balusters’ cutting location with blue tape.

Step 7: Install the new balustrades

Fill the holes you bored in step 3 with the new balusters. To accomplish this, insert the shoe onto the baluster, apply a drop of sticky nails to the handrail hole and a few drops to a base rail hole, but then slide the baluster into the handrails and base rails holes.

Wasn’t the first cut on your old balusters on those scary? You might get a brief worry every time you begin a DIY project, but it’s always worth it in the end.

When working with power equipment and performing DIY tasks, there are inherent hazards. GC Pro Remodeling makes every effort to ensure the efficacy and accuracy of the instructions and material provided, but we cannot be held liable for any losses or damages you may incur while working on your project or using the item.  When you are looking for Steps to Planning a Home Remodeling Project contact us.

Leave a Reply

Your email address will not be published. Required fields are marked *